Page 1 of 1
Camber angle
Posted: Wed Feb 18, 2004 3:47 am
by Lippy91
Just wondering what the camber angle should be. I sent my Moto through a fence during a race and now the front end is off. Any pictures of the front of your quad would be great.:drink:
Posted: Wed Feb 18, 2004 5:22 am
by thunderwolf
thunderwolf!
Posted: Wed Feb 18, 2004 5:41 am
by Ryanstones
Those are some KILLER pics on that site!
:)Awesome Man!
You put that toyota through **** don't ya!? I guess that's yours.:clap:
Posted: Wed Feb 18, 2004 5:54 am
by thunderwolf
Thanks.
Ya, it goes through a lot of nasty stuff. The best thing is that the only parts that I have broken are 2 front birfields in 7 yrs. The second one was totally my fault though hammer down climbing a loose dirt hill with a 3ft rock ledge at the top, front tires came off the ground and landed on hard rock while still spinning and turned hard right so I could make the turn at the top.
Posted: Wed Feb 18, 2004 5:53 pm
by Lippy91
Thanx for the picture. Should the front end be set up at a specific angle or should I just eyeball it.:wow
Posted: Wed Feb 18, 2004 6:11 pm
by Jaybr
I believe for MX most run between 3.5 adn 4 degrees
Posted: Wed Feb 18, 2004 6:22 pm
by Lippy91
Thanx. That sounds about right.
Posted: Wed Feb 18, 2004 10:17 pm
by jfarrar
lonestar recommends 4.5 degrees for mx
Posted: Wed Feb 18, 2004 10:33 pm
by KYmxracer52
Herrmann Racing recommends only 1.5 degrees for MX.