Finished Status Light Project

Message

TheJaspMan · #1 Post by **TheJaspMan** » Sun Mar 21, 2004 1:36 am

Well I finished my status light project. The plans were simple and worked like a charm. Here are the finished results.

.

TheJaspMan · #2 Post by **TheJaspMan** » Sun Mar 21, 2004 1:36 am

TheJaspMan · #3 Post by **TheJaspMan** » Sun Mar 21, 2004 1:37 am

TheJaspMan · #4 Post by **TheJaspMan** » Sun Mar 21, 2004 1:38 am

OCMANJOE · #5 Post by **OCMANJOE** » Sun Mar 21, 2004 1:48 am

nice man but what are they going to show you?

TheJaspMan · #6 Post by **TheJaspMan** » Sun Mar 21, 2004 1:57 am

QUOTE

Originally posted by OCMANJOE
nice man but what are they going to show you?

Low volt, temp and sensor faults.

J. Delaney · #7 Post by **J. Delaney** » Sun Mar 21, 2004 2:39 am

OOOOOHHHHH.....AAAAAHHHHH!! Are you gonna post schematics?

TheJaspMan · #8 Post by **TheJaspMan** » Sun Mar 21, 2004 2:44 am

I cannot take creidt for the R&D. I found the instructions on 'the other site'. But here they are:

Instructions for Cdale Status Lights in Microsoft Word

TheJaspMan · #9 Post by **TheJaspMan** » Sun Mar 21, 2004 2:50 am

I did however locate Ladd Industries who provided all the sockets and plugs on the Cdale. I was able to order the plug and pins used so make the system very nice and clean.

Total cost was about $15. And of that the wire was $3. The light holders were another $5. The LEDs were about $4. Everything else was just change. The parts from Ladd were about $3.5 and they didn;t make me buy the $50 minimum.

And I still have enough stuff to make another one for a buddy of mine.

I mounted them there only so that I could see them while riding. And I do not have a key holder, I moved mine to the headlight bezzel.

J. Delaney · #10 Post by **J. Delaney** » Sun Mar 21, 2004 5:48 pm

Can they be seen in the daylight?