i need help

Message

plummer1111 · #1 Post by **plummer1111** » Thu Jun 17, 2004 9:30 am

i took the fly wheel cover off and noticed there was a puddle of oil in the bottom, i started it up and the flywheel was wobbling a whole lot. i pryed on the flywheel and it moves up and down. did i lose my crank????

bknight · #2 Post by **bknight** » Thu Jun 17, 2004 10:56 am

i would love to say no

but it could be you lost the bearings on that side
do not run it

plummer1111 · #3 Post by **plummer1111** » Sun Jun 20, 2004 12:37 pm

does anyone know where i should start

blaze#52 · #4 Post by **blaze#52** » Sun Jun 20, 2004 12:46 pm

start disassembling, you have to basically pull the motor all the way apart to get that bearing out. probably talk to big winkey and he can get you the ball bearings for it,

Happyboy · #5 Post by **Happyboy** » Sun Jun 20, 2004 2:13 pm

Plumber, have you broken down a motor yet? If not, are you ready to?

plummer1111 · #6 Post by **plummer1111** » Sun Jun 20, 2004 2:15 pm

no i havent tore one down yet but it looks like i am going to real soon.

Happyboy · #7 Post by **Happyboy** » Sun Jun 20, 2004 2:19 pm

Yeah, if that bearing is bad you got a load of work ahead of ya. You will need a flywheel puller. You can go ahead and pull that flywheel off and you should be able to see if the bearing is the problem. (I would think you could) Take the bolt off the flywheel then see if you can pull it off by hand. Do not pry it out. If it isn't loose then you have to use a puller. That will be 1 small step. Check out the manuals and have patience and be very very orderly. You don't want to loose any pieces.

plummer1111 · #8 Post by **plummer1111** » Sun Jun 20, 2004 2:25 pm

thanks for the info any more help would be great

Happyboy · #9 Post by **Happyboy** » Sun Jun 20, 2004 2:58 pm

All I can suggest is download the engine manual and go to town. Pulling the motor is relatively easy. There is a walkthrough on how to do it somewhere around here. Here is pretty much what you are going to have to do.

Pull motor out
Pull flywheel
pull sidecover off
take timing chain off via crank bolt
pull head off
pull piston
pull sleeve
pull crank cartridge plate
replace bearing
put it all back together

The engine manual shows everything listed xcept pulling the motor.

Tear is up!

Happyboy · #10 Post by **Happyboy** » Sun Jun 20, 2004 4:33 pm

Damg ******. I hadn't seen that post. Very nice detail.