Page 1 of 2
AT the end of my rope!!
Posted: Mon Aug 23, 2004 6:44 am
by ducman
Since I have tried everything that I can think of I need a new direction to go in. I have an 02 Blaze that I bought from Haydug about 2 months ago, I can't get the bugs worked out of this thing. The bike had been running fine then it started to just die when I would go to full throttle, once I would come to a stop and hit the starter it would fire right up (might die again on the next lap or not for the rest of the day) The last time I rode the bike started to die about every three minutes at any throttle setting, at the same time after starting the bike about four times it started to blow the fuse. I took the bike to Doug and had him load a new hex code in (the fan wouldn't run with the key off) now the thing will not shut off. Now I start the bike it seems to run fine but the key nor the pingle kill switch will shut the engine off, pop the clutch and kill it then for a couple of minutes the starter will still operate with the key off. I checked the key switch today it is ok and looked the wiring harness over and could see no apparent damage. ANY IDEAS????:furious:
Posted: Mon Aug 23, 2004 7:16 am
by wistech
Have you taken the key switch apart to check for corrosion. Just a thought.
Posted: Mon Aug 23, 2004 2:00 pm
by ducman
I didn't take the switch apart but I checked it with an ohm meter, reads ok.
Posted: Mon Aug 23, 2004 3:52 pm
by CDaleChick
sometimes trying to find out the things that are wrong are really simple, i learned to go through the whole quad piece by piece and just replace anything you can think that could be wrong and anything that possibly looks a little bit worn at all, and to tighten things ALL the time......
and if you do anything, make sure you do it the right way (even if it is more costly) and not just half way and say that will work for now......bc trust me, it doesnt! lol
Posted: Mon Aug 23, 2004 4:20 pm
by Swampdale
Did you check the relay under the air filter?
Posted: Mon Aug 23, 2004 4:38 pm
by ducman
Yes I checked the relay, took the cover off and cleaned the contacts.
Posted: Mon Aug 23, 2004 10:22 pm
by JST
Have you contacted Doug?
Posted: Mon Aug 23, 2004 11:24 pm
by ducman
Yep, was over there today he doesn't know what to think either. Tried a different ecu, had to unplug the starter to get it to stop cranking.
Posted: Tue Aug 24, 2004 12:44 am
by Happyboy
Does this thing have a kill switch like a pingle or something? Sounds like something is wired wrong. Or something is shorting with the starter switch.
Posted: Tue Aug 24, 2004 12:59 am
by wistech
Is the starter relay being energized or has it just failed in a closed position?