Need help
Posted: Thu Sep 16, 2004 10:50 pm
I tried to install the moto map today in my blaze and had some problems. I hooked it up to receive whats on the ecu which is tps closed 0.24 tps open 4.43 fuel injector flowrate 2350 offset 0.88 however when i try to replace this is will not. When i send the new moto map it says "the map is different do you wish to proceed?" I hit yes everything looks good at this point but when i hit receive from ecu to see if it changed it isn't. The original map thats in the ecu has description or id number. I did get a error message that said "receiving bad packets form ecu" then after a few minutes it said received. Also i was wondering about my fan not running it only run after i turn the quad off if i hit the start button with the clutch (like to ingage the fuelpump before starting then it will run. Is this right? I have the battery on charge now just to make sure it's not that but please let me know what you all think. Thanks for your help.