Page 1 of 1
Coil Could Be Burnt?
Posted: Mon Dec 06, 2004 2:41 pm
by scooter-crusher
Guys i hooked a set of headlights on a toggle switch to my battery on my dale (03 cannibal). when i turned them on the bike spit and sputter and died like it was way out of timing and backfired, now the bike is running like crap, dying and backfiring, startsa right up but will barely pull its own ***, i am doing a process of elimination of parts hewre tryong to get this thing running, so you think i could have toasted the coil? it soiunds like it is breaking down, but not sure? any advice?
Posted: Mon Dec 06, 2004 6:18 pm
by speed2424
Have you checked the output voltage coming from the stater?:confused:
Posted: Mon Dec 06, 2004 7:17 pm
by scooter-crusher
no, how do i accomplish that and ensure an accurate reading?
Posted: Mon Dec 06, 2004 7:50 pm
by speed2424
If you have a d&m kit it will show the voltage in the "monitor ECU parameter" tab. Or you can use a volt meter & check across the battery terminals while it is running. But the d&m kit would be more accurate.
Posted: Mon Dec 06, 2004 10:08 pm
by wanablaze
Ok, for more complete instructions, follow the EFI manual. Jaybr posted the diagnosis for the stator and voltage regulator in the forums.
Posted: Tue Dec 07, 2004 1:29 pm
by scooter-crusher
have you guys ever heard of Pro-Design kill switches causing problems? i have one on it now and thinking of switching?