Cannondaleriders

Posted: **Fri Jan 21, 2005 1:12 am**

does anyone have good pics of the stock moto a-arms?

I just want to check out the ball joint set up.

Posted: **Fri Jan 21, 2005 1:15 am**

I've got some loadedin my camera from before and after I installed mine but the stupid thing quit working on me and the place I took it too couldn't fix it! Don't worry, somebody will have some good pics.

Posted: **Fri Jan 21, 2005 1:31 am**

after look through the old post, I guess I should be asking did ATK go with a new design?

I DO NOT want threaded lower ball joints or hiem joints.

Posted: **Fri Jan 21, 2005 3:06 pm**

Good question i'm also interested in seeing what the Stock a-arm set up is like..

Posted: **Fri Jan 21, 2005 4:13 pm**

I thought I had some pics, but can't find them.

the bottom ball joints press directly into the arms, upper uses same ball joint but has a threaded peice that the ball joint presses into, then that is threaded into the arm, so you have some adjustability.

Posted: **Fri Jan 21, 2005 6:15 pm**

I don't have any pics of my Dales posted on this website yet, and both of them have Moto a-arms. I will make a point to get some on here for ya.

When say that " I " will post the pics, that means "CannondaleRider" will post them!!!

Posted: **Fri Jan 21, 2005 9:24 pm**

not sure if this pic has a close enough veiw of the a-arms but they are stock moto arms.

Posted: **Fri Jan 21, 2005 9:32 pm**

QUOTE

Originally posted by BGood
not sure if this pic has a close enough veiw of the a-arms but they are stock moto arms.

I bet we this picture has been shrunk down to allow posting?

Send the original to jaybr@comcast.net and I'll see if I can get a closeup.

Posted: **Fri Jan 21, 2005 10:24 pm**

Does this help?

Posted: **Sat Jan 22, 2005 12:58 am**

thanks:D