Page 2 of 4
Posted: Tue Jan 17, 2006 7:05 pm
by 311racer
Clean out your mail box it's full.
parts
Posted: Tue Jan 17, 2006 10:23 pm
by warren557
Email sent
nerfs
Posted: Tue Jan 17, 2006 11:22 pm
by comander420
Looking for a set of nerfs that go through the frame holes for a good price.
Let me know if you have a set
Thanks
Brad
Posted: Wed Jan 18, 2006 3:09 am
by RoooStEr Pops
I will take the black delets
Posted: Wed Jan 18, 2006 12:34 pm
by bspblaster
e-mail sent
Posted: Wed Jan 18, 2006 2:51 pm
by millermanbg
Moto plastic with stock graphics is sold
bills pipe sold
Other parts
I have set of high rise motocross bent t2s with the clamps they have new grips and cyra hand guards 120
Ac racing front screen bumper 50
Ac racing front non screen bumper 40
Ac racing rear six pack rack 50
Stock front bumper 25
Stock rear grab bar 15
02 stock steering stem with the angles bar mounts
03 stock steering stem with the strait bar mounts
Fuels injectors 25 bucks a pair 5 pairs
Fuel pump 75 bucks each 3 pumps
Fuel tanks 35 bucks I new 2 old style
Honda cr 125 gas cap fixes cannondale problems with bad fuel caps 25
Stock swing arm 50 2 new 1 old style
2 stock axles 75 each
2 Stock bearing carrier with good bearings 75 each
1 lonestar bearing carrier 150
3 Rear brake system 75
Rear wave rotor 50
2 stock rear brake rotors 25
Cannondale moto 440 seat 120
Cannondale moto 440 seat with a little separation of the stitching on the left side of the gripper about an inch 75
Cannibal computer with stock cannibal map make offer
Optimum procal software with plug in wire 300
Good cannondale case hydraulic clutch 200
3 Computer tray 15 each
3 Cannondale air box with sensors 15 each
8 Stock cannondale filter with cage 15 each
Complete swing arm bearing seal kit 50
Complete axle bearing and seal kit 50
2 black widow air filter still in the bags 15 each
03 title cannondale speed rolling chassis
Cannondale frame, sub frame, engine cradle, speed front suspension, rear suspension with rear shock, speed axle, speed front and rear rims and tire. Steering stem 03 and complete front and rear brakes. 800 bucks shipping will have to be worked out
pipe
Posted: Wed Jan 18, 2006 3:06 pm
by millermanbg
moto stock pipe taitanium
pipe
Posted: Wed Jan 18, 2006 3:08 pm
by millermanbg
wiley company pipe shorty has very little time on it sorry it aint clean havent been quite moble to do that stuff
moto plstic with custom graphics
Posted: Wed Jan 18, 2006 3:09 pm
by millermanbg
heres the moto platic wtih my homemade graphics
Posted: Thu Jan 19, 2006 12:43 am
by yamadjs08
Optimum Pro cal software? What is that all about? Buttons and everything or what? Like what all comes with it?
I know what the pro cal kit is, but is this just the software or is this like D&M and everything?
Sorry for stupid questions, Im just a bit confused...:eek:
EDIT: Wait a sec, have you tore this all off the quads yet? You have a complete quad that you would want to sell? I remember you had these for sale as a whole, Im looking for a Cannondale and you arent far from me at all!