Yamaha YFZ 450
Yamaha YFZ 450
Frame gussetted by JB
JB subframe
PWR Radiator
Aftermarket larger oil tank
DG national bumper/grab bar
full skid plate
motor cases polished
Falicon 502cc kit, stroker crank, big bore
Head ported/polished, stock valves
YZ cam
New 05 harness and stator
LSR battery box
GYT kick start kit
Honda thumb throttle
Pro-circuit perch, ASV lever
T2 bar
Houser +2.5 LT, lower red, upper chrome
Houser +1 chrome stem
Houser red round housing swingarm
LSR axle
LSR sprocket hub
LSR brake hub/lock nut
Braking wave rotors front/rear
RPM front hubs
Hiper wheel
ITP holeshot tires
ESR shifter/brake pedal
ESR motor mounts
new 05 seat
Pro-Design filter system
X-factor nerfs
Full Hinson clutch assembly, basket/inner hub/pressure plate
New clutch
Works frame guards
HMF carbon "ballance" exhaust
brake calipers have been powdercoated trans red, cases polished, side covers and valve cover powdercoated. Everything on this bike is either polished, chromed, or powdercoated.
It has only been ridden 10 minutes since I finished it. I need the money for another project. $14,000
You can see pics of this in the open forum.
JB subframe
PWR Radiator
Aftermarket larger oil tank
DG national bumper/grab bar
full skid plate
motor cases polished
Falicon 502cc kit, stroker crank, big bore
Head ported/polished, stock valves
YZ cam
New 05 harness and stator
LSR battery box
GYT kick start kit
Honda thumb throttle
Pro-circuit perch, ASV lever
T2 bar
Houser +2.5 LT, lower red, upper chrome
Houser +1 chrome stem
Houser red round housing swingarm
LSR axle
LSR sprocket hub
LSR brake hub/lock nut
Braking wave rotors front/rear
RPM front hubs
Hiper wheel
ITP holeshot tires
ESR shifter/brake pedal
ESR motor mounts
new 05 seat
Pro-Design filter system
X-factor nerfs
Full Hinson clutch assembly, basket/inner hub/pressure plate
New clutch
Works frame guards
HMF carbon "ballance" exhaust
brake calipers have been powdercoated trans red, cases polished, side covers and valve cover powdercoated. Everything on this bike is either polished, chromed, or powdercoated.
It has only been ridden 10 minutes since I finished it. I need the money for another project. $14,000
You can see pics of this in the open forum.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm