Posted: Mon Sep 19, 2011 2:10 pm
Up for sale I have a Rekluse Z-Start clutch for a Cannondale. It has about 3 hours on it. I took about 2 hours to set it up in my dale, then raced it, and the engine failed (long story) had Tim rebuild it, and didn’t bother to re-install it. Then I sold it to a friend of mine this weekend (as I’m looking at getting out of Cannondales and he’s getting into them) but apparently it wasn’t designed to work with the cable clutch engines. So, we took it back out of there and it’s back in the box ready to go. This clutch usually comes with a C200L1 and a C200L2 spring. After talking to Happyboy a bit, and Rekluse a bunch, I actually wound up running a smaller diameter C150L1 spring inside of the C200L2 spring and it worked perfect. So, in one bag is the clutch as I ran it with those 2 springs. In addition, this kit will come with a C200L3 and a C150L2 for your tuning convenience .
Since it’s low hours, and I have about $350 into it, I’d like to start there. So $350 shipped, obo.
Thanks!
//install guide for anyone interested:
http://www.rekluse.com/Cannondale_01__191-205.pdf
EDIT: I just remembered that the ball that Rekluse uses on the throw-out is a slight different size, and I don't think Tim knew that so I'm guessing that ball is still in my clutch? And my engine is back at his place again... so I'll get another one of those balls coming for whoever wants the clutch, or just knock off the cost of that little ball+shipping.
Since it’s low hours, and I have about $350 into it, I’d like to start there. So $350 shipped, obo.
Thanks!
//install guide for anyone interested:
http://www.rekluse.com/Cannondale_01__191-205.pdf
EDIT: I just remembered that the ball that Rekluse uses on the throw-out is a slight different size, and I don't think Tim knew that so I'm guessing that ball is still in my clutch? And my engine is back at his place again... so I'll get another one of those balls coming for whoever wants the clutch, or just knock off the cost of that little ball+shipping.