MAKE OFFERS! WORST I CAN SAY IS NO OR COUNTER.
03 Frame: No title but clear through DMV. #196. $90.
Subframe: with grab bar. $40. Will combine frame/subframe for $100.
Axle carrier: Brand new bearings. SOLD!
PEP ZPS converted Ohlins rear. Rebuilt over winter and sitting since. SOLD!
ECU Tray 1: $20
ECU Tray 2: $20
Fat bar Mounts: $25.
Foot pegs: $20.
Rear hubs: $40.
Rear hubs: need new studs for wheels. $15.
X-Factor propeg nerfs: with mounts. $125.
ASR long travel arms: Good shape but chips in powdercoat. Take Moto shocks. Brand new hardware, heims, tie rods/ends. ($275 paid for that!) $320.
Starter: $25.
Complete transmission: Mostly assembled. $40.
Rear brake caliper: Powdercoated orange with pads. $25
Front brake calipers: with pads. $40.
Front hubs and rotors: Look good but not personally ran. $40.
Rear rotor hub and rotor: $25.
Rear axle hub: $15.
Handlebar keyswitch mount: has holes from trailtech speedo and status light kit. $15.
Moto handlebar keyswitch mount: Brand new. $10.
Status light kit: Needs new LED's wired on. $15.
13T sprocket: Brand new. $10.
2 Frozen fuel pumps: Repairable? $20 shipped for both.
Tail light: with harness but no bulb. $20.
ATK Seat cover: Never installed. $20.
Engine side cover: Blue. $40.
Engine side cover: Black, needs new powder. $30.
Engine side cover: Chrome. $30.
Front spindles: $30.
Stock Cannibal 03 front end with Arvin shocks: Make offer.
Multiple airboxes: Complete, halves, with or without horns. Make offers on any.
Silver USA Plastic Set: Very good condition. 1 small crack on lower mount hole on rear. Nearly new. Front in stock or race cut; your choice. Includes side spars. $200+Shipping.
ENGINE PARTS:
Exhaust cam: Good decomp, bearing, etc, but one of the lobes fell victim to a sticky bucket. Worth anything to anyone to work with or remove decomp?
Intake cam: Lobes show some wear. Not sure if worth anything but make offer if interested.
Hydraulic case with transmission: Good shape. Has a reweld on back but no issues. $275.
Engine tear down bags: Have all parts to install in engine including cartridge plate, timing setup, gears, oil pumps, etc. $100.
Motorcycle clutch basket/gear: Taller internal gearing. A must on big bore strokers IMO. With plates, springs, screws, etc. $80.
Flywheel: $60.
Ported head: Not sure by who though. No valve buckets or springs but will include a set of used valves for it. SOLD!
Ported head: Complete minus cams. Reangled injectors. $220.
Will discount greatly if you want multiple parts to build this engine. Everything is there but a good exhaust cam.