Cannondale Cable clutch motor bottom end w rebuild z400 crank

Message

m_mcgranahan · #1 Post by **m_mcgranahan** » Thu Apr 30, 2015 3:23 am

Hi,

SO I am facing that fact that I am not likely to finish building this motor to put in the roller I was hoping to sell. I put new crank bearings, new counterbalnacer shaft bearing and had Timbo rebuild a crank with a z400 bearing in it. I shimmed the crank and thats as far as I got. It has a decent used stock asso piston and sleeve that come with it.

Asking $625 obo.

I can text pics if you text me at 319 four nine three 86 seven zero.

Thanks

God bless...
Mark

Ps. I now live Near Minneapolis MN

wistech · #2 Post by **wistech** » Fri May 01, 2015 2:38 am

Thats a darn good deal. If it doesnt sell after a while I will most likely take it. Is it a long or short snout crank. Is the rod a billet or forged? WHat brand main bearings are in it? Does the flywheel come with it?
Thanks
John

m_mcgranahan · #3 Post by **m_mcgranahan** » Thu May 07, 2015 6:06 pm

Hi John,

I don't recall whether it is a long or short snout crank, I believe it had the copper color rod (I think that is the forged one, right?) I don't recall the main bearings brand. (They were ones I bought from Brad) Sorry no flywheel included at that price.

Thanks

God bless...
Mark