Fuel Injector O-Rings, Motor Mount Update

Message

CptHook · #1 Post by **CptHook** » Sat Dec 03, 2005 1:21 pm

As the title states. Finally got the beast going back together after sitting for a year, so Im thinking I might need some new injector o-rings (are the top and bottom the same?), also I need a motor mount update.

I have a pack of those viton o-rings from brad for the fuel quick disconnects, those will not fit the injectors, correct?

speed2424 · #2 Post by **speed2424** » Sat Dec 03, 2005 2:31 pm

If the site sponsors don't have them, let me know. I'll fix you up. BUT check with them FIRST.

Canniboomer · #3 Post by **Canniboomer** » Sat Dec 03, 2005 6:04 pm

full stainless, full stock 10mm diameter, no extended bolt to trim off, and clean bolthead appearance from each side, with plenty of shims.

$35 shipped would include the 4 vitons you need (yes different each end, and not same as disconnect o-rings).

pacrimdm@msn.com

CptHook · #4 Post by **CptHook** » Sun Dec 04, 2005 1:05 am

Thanks guys. Doug was the first to reply via PM so I ordered from him.