Cannondaleriders

Needing the bolts that screw on to hold the rear sprocket to the sprocket hub. The ones that have a nut on the end and use an Allen wrench on the other side.

I'm not sure what they're called but I also need the things where the gas tank mounts in the front. I'm talking about the rubber grommets or whatver and the little steel inserts that the screws go through into the gas tank. If anyone has some, please respond.

The sprocket bolts are the same as 400ex/250r, so you should be able to pick some up at your local honda dealer.

Already tried -- the ones on the 400EX fit the sprocket but they don't fit in the hub right. They're too short to use a nut on the end and are half the width. Thanks for the reply though.

Get ahold of kdeal, he has beatiful stainless bolt kit for the rotor and sprocket.

mcmastercarr has em

I replaced my sprocket bolts with some stainless ones from Ken Deal's kit. If you want my old ones, pay the shipping charges & they are yours.

Hmmm... I havent gotten any yet, and I was told they would work, they look like they would.
Alright, well guys, looks like I need a couple of them too! Speed2424 if Psychosis doesnt take yours or all of them, I will take them, but they are his unless he found some already...

Sounds good . Let me know.

Here is a pic of them courtesy of Doug. You can get one or as many as you need.

How much for all 4?