Cannondaleriders

As the title states. Finally got the beast going back together after sitting for a year, so Im thinking I might need some new injector o-rings (are the top and bottom the same?), also I need a motor mount update.

I have a pack of those viton o-rings from brad for the fuel quick disconnects, those will not fit the injectors, correct?

If the site sponsors don't have them, let me know. I'll fix you up. BUT check with them FIRST.

full stainless, full stock 10mm diameter, no extended bolt to trim off, and clean bolthead appearance from each side, with plenty of shims.

$35 shipped would include the 4 vitons you need (yes different each end, and not same as disconnect o-rings).

pacrimdm@msn.com

Thanks guys. Doug was the first to reply via PM so I ordered from him.