Harley Injectors

Message

skinny · #1 Post by **skinny** » Tue Aug 11, 2009 6:45 pm

I'm looking for a good set of Harley injectors, quad is at Tims and these are hopefully my last pieces to buy. Thanks

Kuma · #2 Post by **Kuma** » Tue Aug 11, 2009 7:46 pm

QUOTE (skinny @ Aug 11 2009, 11:45 AM) <{POST_SNAPBACK}>

I'm looking for a good set of Harley injectors, quad is at Tims and these are hopefully my last pieces to buy. Thanks

If all else fails, call your local Harley Dealer, Dealer near me had them on the shelf.

cannondale27 · #3 Post by **cannondale27** » Wed Aug 12, 2009 2:47 am

Summit has them also.Alot cheaper.

claas900 · #4 Post by **claas900** » Wed Aug 12, 2009 9:58 am

Just look for Pico injectors 29 lbs will be fine.

skinny · #5 Post by **skinny** » Wed Aug 12, 2009 6:11 pm

I found some 29lb injectors on summit website. edl-3583 They are edelbrock pico injectors 29lbs/hr please let me know if these are the same as the harley injectors.
Thanks

http://www.summitracing.com/parts/EDL-3583/

Kuma · #6 Post by **Kuma** » Wed Aug 12, 2009 7:27 pm

QUOTE (skinny @ Aug 12 2009, 11:11 AM) <{POST_SNAPBACK}>

I found some 29lb injectors on summit website. edl-3583 They are edelbrock pico injectors 29lbs/hr please let me know if these are the same as the harley injectors.
Thanks

http://www.summitracing.com/parts/EDL-3583/

Looks the same, '27 or '900 may be able to tell you better if they are the same flow rate.
make sure you are aware that you have to redrill the clips to accomidate the shorter injectors, with the harleys you drill right about where the slight bend is at the bottom of the clip.

claas900 · #7 Post by **claas900** » Wed Aug 12, 2009 8:56 pm

QUOTE (skinny @ Aug 12 2009, 11:11 AM) <{POST_SNAPBACK}>

I found some 29lb injectors on summit website. edl-3583 They are edelbrock pico injectors 29lbs/hr please let me know if these are the same as the harley injectors.
Thanks

http://www.summitracing.com/parts/EDL-3583/

Yup those are them. You could probably shop around with that part number and find a better deal if your willing to put time into. Also, Jinxx44 on here was working on a deal to get the stock ones improved you might see what he has to say?

skinny · #8 Post by **skinny** » Thu Aug 13, 2009 12:17 am

Thanks for all the help guys!! I'll check with Jinxx44 too

peterock · #9 Post by **peterock** » Thu Aug 13, 2009 12:32 am

The below is one area you guys need to keep in mind. I'm not sure what are stock ones are honestly, but I see the ones posted above were listed as such. Not sure if it is correct or not, but does make a difference.

Injector Impedance 14.9 ohms
Driver Type 12 V saturated circuit