Cannondaleriders

Looking for a pair of rubber tail light hangers to put the stock tail light back on the Cannibal.
Also is there an LED tail light that will work that anyone knows of?

I have a pair name your price shipped from vegas

450R is the one I use.You can even use a Z400 switch right in the master cylinder for front it has the threaded holes already.Just buy the switch and screws.

[attachment=9610:Snowbowling_004.jpg]

That little switch wore out on mine in about a year. I have one on the rear brake and it will never wear since its part of the hydrolic brake system.

Mine still works great. 3 years. Maybe I don't use brakes as much
I also used the hydaulic switch for the back.

Did you use a relay to tie in the 2 switches or did you send them both to ground and just tie a hot to light?

Just wired them right to the stock tailight wires.No relay needed since it draws less watts than a stocker.

Thats two switches, so if you wired them together then you would need both of the brakes to be on for them to work. Or did you do them in parallel?

Well obviously both are not required to be activated.So it must be in parallel one + to each switch t'ed off from the + stock tailight wire.This is a simple wiring job and should be as trouble free as any other machine with same switch on it.There are many.You must have just gotten a junk switch.I would try again.

Does the taillight still light up and stay on for night riding? I put a 3 way light in that you can buy at autozone that has a brake light mode and a on light mode so I can have the light for night riding. And wow brake light is crazy bright.