Page 1 of 1
Posted: Sat Aug 08, 2015 1:38 am
by actvpwr
Is there a source for stock replacement ball joints? Retrofit?
Posted: Sat Aug 08, 2015 1:51 am
by POWER MAD MAN
Blackwidow atv sells direct replacements.
Posted: Sat Aug 08, 2015 7:50 pm
by Canniboomer
I have retrofit balljoint upgrade kits for the standard rounded-end A-arms, and for the Moto UPPERS.
For standard arms, you get plus 1/2" each side, and easy camber adjustment without removing anything from the spindle.
For the Moto Uppers?... you can prevent what is happening in the attached action shot:
I don't have full machined retrofit Arm "sets" at this time, but with some reasonable DIY work, you can install a send-out kit for a huge improvement in performance and safety.