Page 1 of 2
Cannible aftermarkets- Help plz.
Posted: Mon Feb 28, 2005 11:35 pm
by exracer12
well im new to cannindales and have not one clue about them so im going to start off with getting some simple things. i need aftermarket
1. handel bars w/ cross bar pad
2. seat cover
3. nerf bars
4. any kind of heel guard so i dont have to worry about gf's fott getting ripped off.
5. steel braded rear brake line.
6. any kind of billet parts.
7. aftermarket front chain guard (covers sprocket)
8. alum gas cap
9. wheel spacers
10 head light covers?
11. aftermarket left side cover.
Posted: Mon Feb 28, 2005 11:42 pm
by Happyboy
I have a set of AC nerf bars that use the stock baskets...If you don't have the baskets I can get those to you also....
$100 plus shipping for the nerfs?
Posted: Mon Feb 28, 2005 11:44 pm
by Happyboy
ebay--2. seat cover
me!!--3. nerf bars
me!!--4. any kind of heel guard so i dont have to worry about gf's fott getting ripped off.
Timbomoose--6. any kind of billet parts.
ebay(mad moto works)--8. alum gas cap
no such thing--11. aftermarket left side cover.
.
Posted: Tue Mar 01, 2005 12:07 am
by exracer12
ok do you have a pic of the nerf's? and will the heel guards work with them?
and if i can send you money thursday i will take them right off your hands if in good cond.
also where can i get handel bars for it? will ones off a 400ex work?
Posted: Tue Mar 01, 2005 12:59 am
by wistech
Before you go blowing your wad on aftermarket goodies did you pull the engine and do all the important updates.crank bearing,stud kit,motor mounts ect. Do you have a D&M kit yet?
Just a little advice from the old fart.
Posted: Tue Mar 01, 2005 3:07 am
by haydug
Or, you could call one of the site sponsors on here, we carry everything you are looking for.. And yes, build the engine before blinging out the bike.
.
Posted: Tue Mar 01, 2005 5:15 am
by exracer12
here is what is done to bike already:
02 cannable
moto mapped
hmf full system
stage 8 upgrade
upgraded motor mounts
z400 crank bearings
upgraded clutch cable
olhins rear shock
steel braded front lines
Holeshots mounted on all 4 itp's
bike is sick but i am in need of some heel guards the most because i take my girlfriend out sometimes and there is no heel guards like she was use to on my old 400ex.
what is an d&m kit?
Posted: Tue Mar 01, 2005 5:19 am
by Happyboy
pm sent....
Posted: Tue Mar 01, 2005 6:02 am
by CannondaleRider
in my opinion....the girlfriend thing isn't the best idea, but oh well:confused:
But yeah, i would get more required things first *cough*D&M Kit*cough*, then nerf bars, then handlebars, etc. etc. Kind of put them in a list of importance
But if you just have a lot of money....go for it, BUY BUY BUY, lol:)
Posted: Tue Mar 01, 2005 8:10 am
by acarli3
I still can't believe people own cannondales without a D&M kit:(