who's wade wilcox

Message

gml1998 · #1 Post by **gml1998** » Sat Jul 19, 2008 1:33 am

I see an 02 Cannibal on Ebay.Motor was done by Wade Wilcox.
I don't think I've heard that name before.Did he do good work?
The Quad looks nice ,too bad it's on the east cost somewhere.

E440fan · #2 Post by **E440fan** » Tue Jul 22, 2008 8:31 pm

Wade Wilcox builds and tunes motors in Torrance Ca. His Company is known as WWE. He was very involved with Cannondale from early on. People on these sites either really like him or have had their problems with him in the past. I have dealt with him recently and have had a good experience.

wistech · #3 Post by **wistech** » Tue Jul 22, 2008 9:53 pm

WWE is the Winky of the west coast.

thedeatons · #4 Post by **thedeatons** » Tue Jul 22, 2008 10:25 pm

Man, you pull NO punches.... LOL

wistech · #5 Post by **wistech** » Tue Jul 22, 2008 10:45 pm

Just look him up on dalers. At first everyone will have high praise for his craftsmanship and how they are going to put out some big numbers on the dyno . Next you hear from these guys if they ever post again back is they are parting out the quad. Ive have had to deal with a lot of his nightmares but not as much as Tim so I have little sympathy. Anybody remember Sandstorm,canniblekuwait,wrist pin snapping,reangle injectors,clutch bands. heck even ATK took it up the rear for quite a while with his disasterous advice. The oly guys who ever had achance were the ones within driving distance he couldnt hide from.