Pro-Tect Fabrications

Message

thedeatons · #1 Post by **thedeatons** » Wed Mar 11, 2009 1:00 am

From what I understand these guys have been around a while, and have a lot of Dale parts on their site!

Thought I would pass the site along!!

http://www.protectfabrications.com/

MyCannibal · #2 Post by **MyCannibal** » Wed Mar 11, 2009 10:57 am

never heard of a swingarm skid being more expensive than a full skid...

UpsMan · #3 Post by **UpsMan** » Wed Mar 11, 2009 11:31 am

I have a funny feeling that if you tried to order a dale part from them, they would not have any. Notice the bottom of their page it says 'Copyright ???? 2002 Pro-Tect Fabrications. All rights reserved.' I think what you have here is someone that doesn't update their web pages very often. Or I could be wrong.

cdsracer · #4 Post by **cdsracer** » Wed Mar 11, 2009 1:21 pm

I like the rear grab bar, haven't seen one like that for a dale before.

speed 450mx · #5 Post by **speed 450mx** » Wed Mar 11, 2009 2:13 pm

thedeatons · #6 Post by **thedeatons** » Wed Mar 11, 2009 4:10 pm

The grab bar is different, a lot like a PRM brand bar. The only thing I don't like about it is those flat pieces hurt your hands when you grab them... Then again if you have to grab in that location you must be really stuck, in which case you deserve some pain anyway...

thedeatons · #7 Post by **thedeatons** » Wed Mar 11, 2009 10:43 pm

Spoke with Dan the owner today... They have all the Dale parts in stock..... Belly pan is cheaper than the rear because fabrication is MUCH simpler. Sounds like a standup guy with a high regard for quality.

UpsMan · #8 Post by **UpsMan** » Thu Mar 12, 2009 12:54 am

Get the **** out of here!! someone is stocking aftermarket dale parts? WTF? Sweet!!

thedeatons · #9 Post by **thedeatons** » Thu Mar 12, 2009 1:28 am

Yep!!! He said someone bought a Dale swingarm skidplate from him the other day! Wonder who in the heck that was?