Do you have any way of checking your TPS?
need help
QUOTE (skippy4103 @ Feb 20 2010, 08:50 PM) <{POST_SNAPBACK}>
ok now it stays running but when you go to take off it stalls... it starts and idles good now but like when you hit the gas over hafe it acts like its going to die...the fuel pump sounds weak like a squicking noise...
Do you have any way of checking your TPS?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (skippy4103 @ Feb 22 2010, 07:28 PM) <{POST_SNAPBACK}>
mil open lamp fault.....what is this
only code that pops up on ecu...and dont know what it is or how to fix it
only code that pops up on ecu...and dont know what it is or how to fix it
That's always there. Nothing to fix. Ignore it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
thats the only thing that shows up on the ecu faults....
iv guted the valves, changed the plug, pulled the relay,replaced the fuel pump, looked at every wire to make sure it was conected,
the only thing im haveing troubles with is the d and m kit...everytime i try to upload the map it freezs and times out... i took off the starter cable and held in the start buttin to keep the ecu on and stlill same problem...
does anyone have any more idles to cheak...???
iv guted the valves, changed the plug, pulled the relay,replaced the fuel pump, looked at every wire to make sure it was conected,
the only thing im haveing troubles with is the d and m kit...everytime i try to upload the map it freezs and times out... i took off the starter cable and held in the start buttin to keep the ecu on and stlill same problem...
does anyone have any more idles to cheak...???
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (skippy4103 @ Feb 24 2010, 10:52 AM) <{POST_SNAPBACK}>
thats the only thing that shows up on the ecu faults....
iv guted the valves, changed the plug, pulled the relay,replaced the fuel pump, looked at every wire to make sure it was conected,
the only thing im haveing troubles with is the d and m kit...everytime i try to upload the map it freezs and times out... i took off the starter cable and held in the start buttin to keep the ecu on and stlill same problem...
does anyone have any more idles to cheak...???
iv guted the valves, changed the plug, pulled the relay,replaced the fuel pump, looked at every wire to make sure it was conected,
the only thing im haveing troubles with is the d and m kit...everytime i try to upload the map it freezs and times out... i took off the starter cable and held in the start buttin to keep the ecu on and stlill same problem...
does anyone have any more idles to cheak...???
Have you monitored the TPS by watching it on the monitor screen and slowly moved the throttle from zero to 100percent? Any dead spots or erratic changes in the tps reading will quiclky show up.
You can disassemble and clean the fuel pressure regulator Remove the snap ring inside the plastic body and pull it out.
Dont go buying parts on the off chance that it might be bad.
One other thing did you check your flywheel to be sure it hasnt spun on hub. A spun flywheel may start but run crappy at high rpms.