Shouldn't I be looking at a pitted - dangerously close to contaminating the engine oil mess? I've had the green engine coolant in the quad since it left the factory. I didn't change it because apparently I misread the forum back in 03'. Dont get me wrong I'm pumped it looks as good as it does, but equally confused?
By the way thanks for all the info I'm getting from these forums. I'm sure there is instructions somewhere here on how to make a donation - I'll be sure and do just that.
Thanks
Valve cover continued...
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
From the gray silicone at the junction points Id say it was changed allready. The factory black ones were some crappy paint and not a good powdercoat so they dont protect much . If it was redone you can see the pits will have been powdecoated over but you need to spin the impellar off to see under it. I have dozens of extra redone covers if you want to change it or you can pay the big bucks for an aluminum one. You need to run evans even with a refurbished cover as it wont protect 100percent . The engine and radiator need to be completely blown out to make sure there is no water in the system before switching to evans.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (cannondale27 @ May 1 2011, 07:31 PM) <{POST_SNAPBACK}>
Is that silicone in corners or corrosion? It looks similar. If so thats what is being talked about.
Thankfully Silicone