That e clip was replaced they just never got the one that shot off out of the motor, and the previous owner said he never heard any weird noises, so I'm thinkin about slapping a new clutch in it and an aluminum impellar andjust throw it back together and ride it also the cartridge plate bolts are all tight
Ya he's used to workin on 2 strokes and he raced this with an un updated motor and said it ran real good, so what do you think I should do check the oil pump and go from there ?
I had a rod bearing go bad way back in 2003 . Other than continually making metal in the filter it sounded fine. The last hour or two the idle needed to be cranked up and intermittant stalling occured. It still ran great until the last few seconds where it seized up in the middle of nowhere. The crank bearings on the other hand tend to get real loud and knock rattle but the engine will keep going until it wipes out the flywheel or the neghbors call the police from the sound. Either way metal in the filter means teardown or you will be very sorry.
Well I took the engine oil drain plug off and the plate behind that and there was some oil left in there. I took a couple different magnets and pulled out no shavings at all, I don't understand what it could, any ideas ?
metal in the sump is crank related..if you have metal in the filter and not the sump it would be coming from the camshaft area. Did you pull the cam cover off?