Page 1 of 1
Posted: Mon Apr 07, 2008 6:45 pm
by Canniboomer
front?, no
rear?,...I hear the Honda 450r are the best fit (from a member's recent post).
or give a call for the stock used one, since you need only 1 piece.
The rear offset may be different with the Honda hub, and maybe a matching pair is needed anyway if you decide to change.
Posted: Mon Apr 07, 2008 7:40 pm
by jesshamner
Yep, you could do a search as this was answered recently. Honda hubs work.
Posted: Tue Apr 08, 2008 1:13 am
by cannondale27
I know Cannondale hubs fit on a Yamaha Raptor axle so I would think other way should work also.
Posted: Wed Apr 09, 2008 3:11 am
by Dachshund
Rear hubs? Honda 450r 400EX 250x 300ex fit and gain 1 1/2" in width.
Posted: Wed Apr 09, 2008 11:54 am
by cannondale27
Honda 250r spline is way bigger at least all the ones I have seen.
Posted: Wed Apr 09, 2008 5:45 pm
by Dachshund
Honda 250r spline is way bigger at least all the ones I have seen.
Well buggers, you are correct. I just tried one again and looked closely and sure enough they are way bigger. I had tried it awhile back and it slid right on and felt good but didn't really look close at it. I edited my post so as to not have wrong info out there, but let it be known I was incorrect and 250R hubs will not work.