clutch adjustment

Message

TG2891 · #1 Post by **TG2891** » Wed May 14, 2008 2:58 am

Can anyone tell me the proper way to adjust the hydraulic clutch.
From the manual - Hold the outer ring with cer-clip pliers, loosen the lock nut, screw in the adjustment bolt, back out 3 full turns and then tighten the lock nut.
OK well the question is how far do you screw in the adjustment bolt(allen)? Untill it stops or untill it touches the rod and snugs things up?

Thanks

cannondale27 · #2 Post by **cannondale27** » Wed May 14, 2008 11:29 am

Till it stops. By stop I mean with two fingers it wont go any further. What your doing is pushing the slave cylinder all the way in till it bottoms. Then backing off 3 turns.

wistech · #3 Post by **wistech** » Wed May 14, 2008 2:21 pm

When it bottoms out the clutch plate will start to lift off the pack.

TG2891 · #4 Post by **TG2891** » Fri May 16, 2008 11:26 pm

Thanks Guys