Cannondaleriders

Can anyone tell me the proper way to adjust the hydraulic clutch.
From the manual - Hold the outer ring with cer-clip pliers, loosen the lock nut, screw in the adjustment bolt, back out 3 full turns and then tighten the lock nut.
OK well the question is how far do you screw in the adjustment bolt(allen)? Untill it stops or untill it touches the rod and snugs things up?

Thanks

Till it stops. By stop I mean with two fingers it wont go any further. What your doing is pushing the slave cylinder all the way in till it bottoms. Then backing off 3 turns.

When it bottoms out the clutch plate will start to lift off the pack.

Thanks Guys