Page 1 of 1

Posted: Wed Aug 12, 2009 11:52 pm
by raremoto440
I still can not get any power to my 03 moto. The battery is charged, and the fues is good. When I turn the key on the tail light works but flickers. When you turn the kill switch on the light dims ,and when you hit start button the ecm clicks and the solinoid buzzes but thats it. Need help with this please.

Posted: Thu Aug 13, 2009 12:36 am
by gerk101
QUOTE (raremoto440 @ Aug 12 2009, 11:52 PM) <{POST_SNAPBACK}>
I still can not get any power to my 03 moto. The battery is charged, and the fues is good. When I turn the key on the tail light works but flickers. When you turn the kill switch on the light dims ,and when you hit start button the ecm clicks and the solinoid buzzes but thats it. Need help with this please.

i had a simular problem it changed my voltage rectifier and it took care of it . if not sounds like the stator could be shorting out check the wires behind it.

Posted: Thu Aug 13, 2009 11:29 am
by MyCannibal
Is it a brand new battery?..sounds like a bad battery.

Posted: Thu Aug 13, 2009 5:24 pm
by cdale490
QUOTE (MyCannibal @ Aug 13 2009, 12:29 PM) <{POST_SNAPBACK}>
Is it a brand new battery?..sounds like a bad battery.

check your ground wires

Posted: Thu Aug 13, 2009 10:37 pm
by gerk101
QUOTE (MyCannibal @ Aug 13 2009, 12:29 PM) <{POST_SNAPBACK}>
Is it a brand new battery?..sounds like a bad battery.

sounds like the stators shorting and draining the battery

Posted: Thu Sep 03, 2009 2:56 am
by raremoto440
QUOTE (gerk101 @ Aug 13 2009, 11:37 PM) <{POST_SNAPBACK}>
sounds like the stators shorting and draining the battery

Thanks for the help is was the stator I changed it and put new battery in and it rips again.

Posted: Thu Sep 03, 2009 4:53 pm
by NRath
Where was the nick in the wire? At the clip? there was an update to add some sheathing to the wire as it goes through the clip.