Page 1 of 1
Posted: Thu Mar 19, 2015 10:23 pm
by cannondalemaine
I was wondering. If anyone would no other parts from other quads that would work on cannondale...i see a bunch of ppl posting about 250r parts working etc...and some plastics. Thx
Posted: Fri Mar 20, 2015 9:26 am
by who_gives_a6
There's some parts that work with little to no modification but one I'll throw out there just because I swapped a set earlier today is the rear hubs. 400EX/450R rear hubs bolt up and gain 2" of width in the rear.
With an LSR MX axle you only get 48" so Honda hubs put you right at 50".
Posted: Fri Mar 20, 2015 4:50 pm
by SlOoT
Some parts from the Dinli/Masai 450 quads can be used, like spindles, hubs and discs.
Rear sprocket is honda 400ex, front sprocket is KTM.
Thumb throttle from a ltz400 fits.
Posted: Fri Mar 20, 2015 7:13 pm
by ShifT714
i have a throttle/cable from an ltr450 on mine, set of rath pro pegs(cannondale mounts) and a trx450 front master cylinder along with the 400ex rear hubs...
the 250r plastics will only work if you can find the aftermarket subframe/fuel tank to accept them..
also the front ends from a 250r/400ex will bolt the cannondale frame but you will need to use the r/ex spindles, hubs and brakes..
Posted: Fri Mar 20, 2015 10:28 pm
by cannondalemaine
Thx alot guys on the feedback ill have to try some of those parts..j