Drag quad
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (jesshamner @ Jul 1 2015, 02:38 PM) <{POST_SNAPBACK}>
Did you just get it finished? Why has it never been to any of the group rides?
Just got it done zero seat time. Need to re dyno it with the aluminum drag axle
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Yep awesome and congrats!
Also consider hole drilling the underside seat pan.
You might be able to drop another 1/2 pound of excess black plastic.
and you may not even need or be using the seat knob, or use a nylon bolt instead. Man you guys are helping to re-establish the good rep of our machines. Thank you from all of us.
Also consider hole drilling the underside seat pan.
You might be able to drop another 1/2 pound of excess black plastic.
and you may not even need or be using the seat knob, or use a nylon bolt instead. Man you guys are helping to re-establish the good rep of our machines. Thank you from all of us.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
The seat pan has already been lightened. And someone owes me a lithium ion battery just waitng for it to come in. Those r just rear tires that where installed to move around. Found out with the horsepower that it made a wheelie bar is more than needed to be able to fully get it out of the hole. It was a learing experience so far the front end on the bike now has been removed and thrown out. It got severly twisted. So there has been changes made and it's going to be a little more forward to try to help keep it planted.