trailtech headlight setup
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
We just trim the wires on each side, about 2-1/2 inches from the bulbs, and connect to each light. The standard Trailtech connectors are included, but it's better to solder for a permanent installation. The cables don't interfere with the light yoke. For the upright mount, you can route ALL cables inside the extension yoke. For the inverted mount, all the cables run underneath -- both setups work fine.