Canniboomers Balljoints Installed
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
QUOTE (Canniboomer @ Oct 21 2010, 01:13 PM) <{POST_SNAPBACK}>
dalewannbe,....the OD of the bushings are 13/16", and the ID of the stock pipe ends are already the same 13/16",....so you just need to clean up the ends of your crosscuts to that same diameter.
But also CALL me. There have been 2 reports of these balljoints tightening up after water crossings,...(first incidents per supplier after 15 years) so each joint is now getting pre-checked for ample grease. Please call during install for other misc info as needed,.... thanks Dave 360 574-2613.
But also CALL me. There have been 2 reports of these balljoints tightening up after water crossings,...(first incidents per supplier after 15 years) so each joint is now getting pre-checked for ample grease. Please call during install for other misc info as needed,.... thanks Dave 360 574-2613.
I'll call you when I tackle this project, it probably won't be for a while.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm