Canniboomers Balljoints Installed

Message
Author
dalewannbe
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#11 Post by dalewannbe »

27's front end was buttery smooth. biggrin.gif

dalewannbe
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#12 Post by dalewannbe »

QUOTE (Canniboomer @ Oct 21 2010, 01:13 PM) <{POST_SNAPBACK}>
dalewannbe,....the OD of the bushings are 13/16", and the ID of the stock pipe ends are already the same 13/16",....so you just need to clean up the ends of your crosscuts to that same diameter.

But also CALL me. There have been 2 reports of these balljoints tightening up after water crossings,...(first incidents per supplier after 15 years) so each joint is now getting pre-checked for ample grease. Please call during install for other misc info as needed,.... thanks Dave 360 574-2613.


I'll call you when I tackle this project, it probably won't be for a while.

dalewannbe
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#13 Post by dalewannbe »

I got my kit and I am going to be giving this a try.

speedracer
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#14 Post by speedracer »

I am in need of new balljoints but not looking for stockers,is this kit still around for 02 speed arms?Thanks.

Post Reply