Page 1 of 1
Posted: Thu Jan 08, 2009 7:17 pm
by jacobw
I need the parts for the 12mm size i have the 10mm and it will not work with my swingarm.
Posted: Fri Jan 09, 2009 4:36 am
by rayspeed
I ran into this last weekend and I dont know if it was kosher or not but I just drilled the bushings out to size. They were just aluminum and the hard bushing inside was big enough allready.
Posted: Fri Jan 09, 2009 12:47 pm
by cannondale27
Thats odd they are normally steel.Anyway if you need some let me know.Canniboomer has some OEM ones in stock.Mine I just cut to size.
Posted: Fri Jan 09, 2009 10:38 pm
by jacobw
yes i need some it would be easier for me to change them then mess with trying to drill them.
Posted: Sat Jan 10, 2009 5:11 am
by UpsMan
drilling them takes two minutes, tops.
Posted: Sat Jan 10, 2009 6:20 pm
by rayspeed
I guess they were steel... either fairly soft or the bit I was using was very sharp.
I clamped the whole shock in a vise on the edge of the bushings to keep them from spinning.
Took only minutes.
Ray