Ive been tring to get this thing to idle right for a long time today and I need some ideas on what to look for next because i'm out.
problem:
wont start up unless I crack the throttle to about 11% on the throttle position. and wont idle if i let off.
what ive tried:
tried adjusting the offset and flowrate.
offset was .8
flow was 2500
any other ideas guys, because im so tired of tring to figure it out by myself.
thanks.
DM and idle
OK I think I figured it out after I had a few beers to clear up my head.
But....
Needs to be richened up though the header was glowing just sitting at idle.
I've bumped the IO to 1 and the flow is down two 2400 and it still glows. Its a full HMF BTW.
the thing dosent pop or sputter when revved up but that header is getting awfully warm. I'll take it for a ride tomorrow to make sure of no pops or anything.
is this just a thing I will have to put up with or is something still wrong?
****** could you look up the orignals for me? I want to double check. and for future refrence.
Frame:
586FD31G53B000058
Engine
AAA5B3000029
But....
Needs to be richened up though the header was glowing just sitting at idle.
I've bumped the IO to 1 and the flow is down two 2400 and it still glows. Its a full HMF BTW.
the thing dosent pop or sputter when revved up but that header is getting awfully warm. I'll take it for a ride tomorrow to make sure of no pops or anything.
is this just a thing I will have to put up with or is something still wrong?
****** could you look up the orignals for me? I want to double check. and for future refrence.
Frame:
586FD31G53B000058
Engine
AAA5B3000029
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
No I think I took care of the idle. I got it set at around 2100 at about 3.6%.
If I let it just sit there and never even give it any revs the header still starts to glow.
thanks 27, i'll give that a try if that dont work i guess ill have to start reading up on HEX codes because I know nothing about them right now. :confused:
or should i download a new code anyway just to be certain, it cant be that hard right?
If I let it just sit there and never even give it any revs the header still starts to glow.
thanks 27, i'll give that a try if that dont work i guess ill have to start reading up on HEX codes because I know nothing about them right now. :confused:
or should i download a new code anyway just to be certain, it cant be that hard right?
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm