Looking to see if anyone has taken apart or researched what the pin configuration of the D&M Diag cable is. I have a D&M cable that came with my kit but was looking to have a spare to take with me on trips so the only cable I have does not get destroyed. The wiring schmatic shows where the wires are routed to and that 2 pins out of the 4 send and receive, one is ground and the other I think it is used to turn the green LED on and tell you that you are ready to go.
If anyone has figure this out let me know.
Diag Cable Pin Configuration
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm