Question about Injector flow rate/offset

[Honeycutt]

I finally got my D&M kit and hooked it to my Speed. I checked the faults and everything was great. It has the speed map in it (ID 31300). I was comparing the stock map to what I have and the Injector flow rate was 2400 and the Injector offset was 1.40. The injector flow rate for the stock map is 2603 and injector offset was .88. The Quad runs perfect, it just thru up a flag with the numbers not matching up. I would like to know if those numbers are safe. Also, can a blaze/speed map be run on stock exhaust:confused: Thanks for all the very usefull information on this board.:clap:

[Honeycutt]

So when I down load a new map, I need to adust the injector and flow rate to match my quad , and leave everthing else alone.

Thanks for the response:)

[SCOTMO58]

when adjusting the flowrate, how do you know how much to go with the offset. I put a 450 in and had to addjust my flowrate from 2650 to 2450. Should I have to adjust the offset?

[Honeycutt]

Thanks for the help:) People like you are the reason I visit this site everday. Again thanks Honeycutt