Cannondaleriders

I'm reading that the advanced timing of the speed or x440 maps may actually hinder power on the stroker motors. If this is the case, what timings on the stock maps have people found to be the best? I can drop the fuel setting from the map we've created so far and change the timing to another map if we think it will create more power.

Any comments or suggestions??

We were playing with timing last dyno runs.Lowering timing on top end was giving more power.This was on the Big Stroker.

C27, when you say "top end", what RPM range are you looking at that the decrease in timing helped out? If I recall right you guys were looking at max HP @ 8000 RPM or so on the strokers?

also, what maps timing did you use that you saw gained some HP?

My stroker maxxed HP @9000 RPM on a stock 03 Moto map.

Hmmm. I wonder if the the less timing on the Moto Map would create HP in the stroker motors above 8000rpm versus the speed timing we've been using???

Timbo was doing this.It was all about 8000 up and max throttle.Saw two horse.It was the Acarli27 map.Now called Toms map.Its on my laptop so will post it later so you can see.

cool. thanks.

Not sure which one it is.But its one of these.

Will look later to see which one it is.