ELIMINATOR MAP FOR HARLEY INJECTORS

Message

timbomoose · #1 Post by **timbomoose** » Tue May 02, 2006 8:30 am

This map is ONLY for use with Harley injectors made for big bore ported strokers with open air filter setup.Using this map with stock injectors can damage your motor from lean condition.Map is only for Harley injectors.Starting parameter use default in map.Approximate 2700flowrate and .88 offset.Map has been 100% field tested and rips!!There's a reason wht its named the eliminator!Have fun!

toothandnail · #2 Post by **toothandnail** » Tue May 02, 2006 1:16 pm

can't wait to try, my inj. should be here tomorow , just finished engine today, race on sat.
as homer would say WOOOO-HOOOO

GDITheman · #3 Post by **GDITheman** » Tue May 02, 2006 3:07 pm

can the HD injectors be used on other configs like 468 engines as a possible replacement for stock injectors?
thanks for the map timbo.

T-Rex · #4 Post by **T-Rex** » Sat May 06, 2006 10:55 pm

Whats the part number for the HD injectors...

cannondale27 · #5 Post by **cannondale27** » Sun May 07, 2006 3:41 pm

Its # 27609-01A I believe for 88ci motor.

Only two reasons to use these.One is if you have the Winky reangled injectors and you want to make it closer to right.

Two if you are ported,no airbox and AFR has shown you cant tune leanness out.Then be prepared to do some map tweaking since all the motor combos do run a little different.

T-Rex · #6 Post by **T-Rex** » Sun May 07, 2006 9:40 pm

Thanks buddy, I knew someone had to have an answer.