now quad wont start
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
i just did an engine rebuild with a cp piston. i broke in the engine per timbos specs and everything was fine. Then i installed an intake from cannonboomer and it was fine, ran good. started to tune the engine cause it was running rich for the brake in. I started to work the numbers and as i was driving it and the engine cut out. i brought it in reajusted it and it wont start now
rethrottle cal. .3 \4.4
stepper 165
throttle 7.1 open
animal 128 map
has spark
has fuel
fuel is new
has very good compression
no faults
what i am getting is a little backfire through the throttle body. But it sounds like it wants to start.
thanks paul
rethrottle cal. .3 \4.4
stepper 165
throttle 7.1 open
animal 128 map
has spark
has fuel
fuel is new
has very good compression
no faults
what i am getting is a little backfire through the throttle body. But it sounds like it wants to start.
thanks paul
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Also, put a little red loctite on the nut when you torque it down. And make sure that there isnt any of the old key still in the keyway, I had troubles with this forever, a little sliver in there that looked like it was part of crankshaft. After I got it out key fit perfect, and I loctited it and havent had a problem since... (knock on wood)