Trinity exhaust and mapping.

Message

Jaybr · #11 Post by **Jaybr** » Sun Nov 17, 2002 7:30 pm

I know you can adjust those settings, you just don't want to leave them set at whatever comes with the map your installing. In fact I need to lower my offset a bit because I think I'm running a little rich.

As far as the ECU's are concerned: I am on my third one now with no problems. The first replacement I got had the exact same problem as soon as I installed it and tried to set it up. Both of the first 2 went back to the factory and where successfully reloaded with dealer cal, and both had the exact same failure when I got them back and tried to load them - on a bench cable off the quad. I even sent my software and cable back to Optimum and it checked out fine. Optimum eventually got the ECU's back for testing, but they never gave me the results.

MartyQUADSHOP · #12 Post by **MartyQUADSHOP** » Mon Nov 18, 2002 7:57 am

We just installed a HMF on my cannibal with the blaze map.
Its work great and I can tell a big difference in power which works very smooth.

Birddog5150 · #13 Post by **Birddog5150** » Wed Nov 20, 2002 9:15 pm

Whizzard, how are you making a slip-on work in place of the toaster? Please fill in..What brand slip-on are you talking about?:confused: