temp light flashing after map load

Message

captainpabst · #1 Post by **captainpabst** » Fri Feb 27, 2009 6:22 pm

tried loading the terminator map (have a 450 with ported head and open air) and was running fine before the update. now i get the green lit up, the yellow lit up and a flashing red. tried reloading hex (never been able to make happen), went back to old map still not starting with the flashing red, can set and read settings from the ecu, whats next. thanks
-Eric

cannondale27 · #2 Post by **cannondale27** » Sat Feb 28, 2009 3:44 am

Flashing red is temp.Is it possible some wiring got plugged into wrong spot.Maybe coolant temp and pickup switched?

captainpabst · #3 Post by **captainpabst** » Sun Mar 01, 2009 2:16 am

QUOTE (cannondale27 @ Feb 28 2009, 03:44 AM) <{POST_SNAPBACK}>

Flashing red is temp.Is it possible some wiring got plugged into wrong spot.Maybe coolant temp and pickup switched?

nope. everything was fine till i tried loading maps. now it flashes when i hit the green button, but it does not run.