Page 1 of 2

Posted: Sat Jul 09, 2011 3:25 am
by haulinit
I was trying to load a moto map into a friends cannibal tonight. To start my cable a optimum cable the green light is on as soon as you plug it into the plug on the quad, with the key on but as soon as you plug it into the serial port the light goes out but the first time I was able to get the faults. After that I tried loading the moto map but I keep getting the 125 error. I tried the cable on my dale and no light but was able to get the error faults to work. Now the other quad wont start or kick the fuel pump on. I'm confused and hoping I didnt brick the ecu some how.

Thanks
Shawn

Posted: Sat Jul 09, 2011 3:28 am
by claas900
I've never had the light problem, But I have forgot many times with working with other bikes to make sure I select there bike/ECU.

Posted: Sat Jul 09, 2011 3:39 am
by haulinit
QUOTE (claas900 @ Jul 8 2011, 10:28 PM) <{POST_SNAPBACK}>
I've never had the light problem, But I have forgot many times with working with other bikes to make sure I select there bike/ECU.


I did choose the correct ECU, the other bad thing is they are both my ECU's one was my spare, the one that came with the my friends quad was toast so I loaned it to him to see if that was the problem now I'm afraid I toasted my spare.

Posted: Sat Jul 09, 2011 9:25 pm
by cannondale27
Check the pins in the cable maybe one pushed back.

Posted: Sun Jul 10, 2011 12:43 am
by haulinit
QUOTE (cannondale27 @ Jul 9 2011, 04:25 PM) <{POST_SNAPBACK}>
Check the pins in the cable maybe one pushed back.


Tried it no luck.

Posted: Mon Jul 11, 2011 1:25 am
by haulinit
I ordered a USB to serial converter to see if by chance it is my old laptop that is causing the problems, it can be a bit buggy.

Posted: Tue Jul 12, 2011 12:40 pm
by Scooter
It sounds to me like you have lost the hex in the ecu try to reload it then the map. Do not forget to hold down on the start button with the starter solinoide disconected while you are reloading the hex if you do not have a newer harness.

Scooter

Posted: Tue Jul 12, 2011 4:16 pm
by kdeal
My hero! rolleyes.gif

Posted: Tue Jul 12, 2011 5:01 pm
by haulinit
QUOTE (Scooter @ Jul 12 2011, 07:40 AM) <{POST_SNAPBACK}>
It sounds to me like you have lost the hex in the ecu try to reload it then the map. Do not forget to hold down on the start button with the starter solinoide disconected while you are reloading the hex if you do not have a newer harness.

Scooter



I cant get it to "talk" now I keep getting the 125 error.

Posted: Wed Jul 13, 2011 11:54 am
by Scooter
When they will not talk it sometimes is that they have lost the hex and the ecu does not know what you are trying to do. That is why you have to force the power on and force feed the hex to it. Did you try that yet?

Scooter