What map for this setup?

Message

SlOoT · #1 Post by **SlOoT** » Thu Jun 20, 2013 7:39 pm

Getting my moto ready again, but I changed my setup a bit. Now I need to know what map you guys recommend.

432cc stock bore and stroke,
FMF Ti exhaust, quiet core,
46mm ported head + TB,

Cyclone velocity stack built into stock airbox (Need to get noise down)

Cams 110 intake and 108 exhaust.

At this moment I have the Trinium map I think (the one recommended for timbo porting), but went from pod filter to airbox.

Thanks

wistech · #2 Post by **wistech** » Thu Jun 20, 2013 10:14 pm

Your cam timing might be to high for a 432 with a quiet core. For an open exhaust it would be fine. More like 107 intake and 105 exhaust will keep it snappy in the low and mid range. Since the 432's seem to be more prevalent these days I might have some maps you could try out. PM me your email . Can I assume your injectors are stock since this engine wont need them.

SlOoT · #3 Post by **SlOoT** » Fri Jun 21, 2013 6:15 am

Yes injectors are stock.

I used to run a 109 intake and 107 exhaust and that ran realy good.
With the 110/108 timing I did lose low-end power, this winter I'll drop the engine and change the timing.

I have send you a PM, thanks

werty · #4 Post by **werty** » Fri Jun 21, 2013 6:46 pm

Thanks for the trinium map my quad runs so much better. Is there a higher rev limit version?

SlOoT · #5 Post by **SlOoT** » Wed Aug 14, 2013 11:14 am

Wistech I got your map. I did sent you a mail back but didn't get a reply.

I was wondering if the map was made for pod filter or airbox? My quad has your cyclone velocity stack built into a stock airbox.
And maybe I need to run a stock '02 exhaust instead of the fmf titanium.