Ok, was trying to get my Cannibal in top running condition, but I am kind of lost as far as tuning it goes. The settings are as follows:
Min: 0.28v
Max: 4.58v
TB Leakage: 0.0
FI flow rate: 2550
FI offset: 1.0
My tb% at 2100-2200 rpm is around 2.8-3.0%. I read it should be 3.5-4%. I then adjusted my offset to .80 and my tb% was 3.6 at 2200 rpm but the quad seemed to hang slightly off revs...is this normal? Also, am I supposed to change the flow rate after adjusting the offset? I tried to read harry motos guide but I am a little confused. Any help is appreciated.
Thanks,
FBR
Tuning Assistance Please
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
I live in Pittsburgh, where are you located? You should look at it as a carb. The offset is the pilot and the flow rate is like the main jet to put it as simply as possible. 3% is where I like to be when hot and at 2200 rpm it sounds like you are a bit lean still. When the offset was 1 was it better or worse? It is tough to diagnose without it being there in front of you.
Scooter
Scooter