Posted: Sun Mar 22, 2015 7:34 pm
Ok, was trying to get my Cannibal in top running condition, but I am kind of lost as far as tuning it goes. The settings are as follows:
Min: 0.28v
Max: 4.58v
TB Leakage: 0.0
FI flow rate: 2550
FI offset: 1.0
My tb% at 2100-2200 rpm is around 2.8-3.0%. I read it should be 3.5-4%. I then adjusted my offset to .80 and my tb% was 3.6 at 2200 rpm but the quad seemed to hang slightly off revs...is this normal? Also, am I supposed to change the flow rate after adjusting the offset? I tried to read harry motos guide but I am a little confused. Any help is appreciated.
Thanks,
FBR
Min: 0.28v
Max: 4.58v
TB Leakage: 0.0
FI flow rate: 2550
FI offset: 1.0
My tb% at 2100-2200 rpm is around 2.8-3.0%. I read it should be 3.5-4%. I then adjusted my offset to .80 and my tb% was 3.6 at 2200 rpm but the quad seemed to hang slightly off revs...is this normal? Also, am I supposed to change the flow rate after adjusting the offset? I tried to read harry motos guide but I am a little confused. Any help is appreciated.
Thanks,
FBR