Mil tool knowledge needed.

Message

JST · #1 Post by **JST** » Fri Oct 01, 2004 2:07 am

I changed over to the "R" kit and the quad is gettin a ton of air with the front being open.So now I'm gettin a pop every now and again and I belive its now lean.Has anyone got a pic of a Mil toll/I don't even know what it looks like or is it easy to use?Anyone got 1 they want to get rid of?

cannondale27 · #2 Post by **cannondale27** » Fri Oct 01, 2004 12:04 pm

On the front of the 500ECU there is a hole with a allen screw in it above that there is a swoosh triangle with narrow and wide in the casting of ECU.If you turn the allen screw toward the wide part of swoosh it will make all the settings richer.!!This screw is VERY touchy!!a 1/8 turn is a big adjustment.If you do get a mill tool you can calibrate throttle and set low,mid,high mixtures.Only way to change rev limiter is to get a bike 500 ECU.

JST · #3 Post by **JST** » Fri Oct 01, 2004 11:09 pm

Does the allen screw adjust everything at once?If I have the mil tool can I adjust each (low,mid,high) individually?Will I have to recalibrate my throttle?Does the popping indicate a lean condition?

JST · #4 Post by **JST** » Sat Oct 02, 2004 12:42 am

I was told a bike ecm would make it faster,true?

From the geginning,how do you use the mil tool?

cannondale27 · #5 Post by **cannondale27** » Sat Oct 02, 2004 1:51 am

Yes the screw adjusts all the settings.Honestly I would have to read directions again but it uses switches and a dial to make your settings.Bike ECU has a higher redline and maybe more aggressive mapping.Yes it does make it faster.

JST · #6 Post by **JST** » Sat Oct 02, 2004 2:16 am

Do you have a mil tool?Can you please post a pic of it?

cannondale27 · #7 Post by **cannondale27** » Sat Oct 02, 2004 2:22 am

Its at the shop.Tomorrow I will get the instructions and post them for you.Iceracer used it alot on his dyno tuning.You might try PM ing him.I believe last time I used it was two or three years ago so my memory is very bad.(old age)LOL.

cannondale27 · #8 Post by **cannondale27** » Thu Oct 07, 2004 12:45 am

Here are some of the instructions.
http://www.cannondaleriders.com/vbb/showth...=&threadid=8261

fx400 · #9 Post by **fx400** » Thu Oct 07, 2004 12:56 am

I have 2 mc500s. 1 in my fx400, and the other i bought as a spare. how can i tell if my spare was for a fx400 or mx400?

cannondale27 · #10 Post by **cannondale27** » Thu Oct 07, 2004 2:16 am

I would ask Maz or Kram about that there must be a way.

Cannondaleriders

Mil tool knowledge needed.

Mil tool knowledge needed.

More questions.

cannondale27