axle bearings...

Post your R&D threads here, what are you working on?
Post Reply
Message
Author
MyCannibal
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#1 Post by MyCannibal »

I just bought an all balls axle bearng kit. Could someone give me a heads up on how to install and what to look for? Thank you.

cannondale27
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#2 Post by cannondale27 »

Pop out the seals.Mount carrier in a vice.Heat it up good with propane torch.Bearings will almost fall out.Reverse order to install.

MyCannibal
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#3 Post by MyCannibal »

thanks.

mydreamride
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#4 Post by mydreamride »

Pop the seals off the new bearing and visually check to see if the bearings have grease, if not pack them with waterproof grease. I know the Moose kit I bought one bearing had zero grease in side the bearing.

haydug
Posts: 0
Joined: Wed Mar 10, 2021 10:41 pm

#5 Post by haydug »

drill the carrier while the bearings are out, install a zerk fitting. Pop out the seals on the inside bearing, and inside seals of outside bearings. Put it all together, and grease the sh** out of it before installing.

kdeal
Posts: 4
Joined: Wed Mar 10, 2021 10:41 pm

#6 Post by kdeal »

Good tip. Where are you installing the zerk? Inboard of the inner most bearing? On the center section or more towards the bearings themselves?

Thanks for the tip.

Post Reply