The X pipe
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Yes we are really limited at the head.Timbo has some ideas.Those pipes I gave him could be welded together and tubing cut on sides and then welded to the the pipes at a slight bend.In effect it would look like one ovaltube coming out of head and then seperating into two.Actually it would be seperated but you just wouldnt see it.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
Sure cool.Dont foget to go in there when your done welding and cleanup anything hanging there.Should be easy to get at.Those bungs are 4130chromemoly so they weld real nice.The ID is also matched to the ports that are offset to the left.So there is a right and a left one.Cant wait to see what happens.Even x-pipe is barely bigger than our ported exhaust ports.Good luck!
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm
One of my good friends is buliding a 812cc raptor right now so ive taken a sudden interest in the 700 motor. Ive read quite a bit on how they are getting the power out of them and for all out horsepower with the broadest curve a true dual exhaust has to be part of the set-up. They will make good power with a single, but the curve isnt nearly as nice without the duals. Pretty much sounds like the same thing we found out with my quad.
-
- Posts: 0
- Joined: Wed Mar 10, 2021 10:41 pm