Low Cost D&M/Map Select/Rider Trim/Map Editor Project

Message

02Cannibal · #1 Post by **02Cannibal** » Fri Mar 04, 2005 8:58 pm

As some of you may or may not know, there is a D&M replacement project in the works. We are looking for feedback so we know which direction to take the project. The main post is over on Cannondaler.

http://forums.cannondaler.com/viewtopic.php?t=7119

You can post replies back on this board if you are not a member over there, but please don't post on both boards.

Thanks!

DIRTRACIN · #2 Post by **DIRTRACIN** » Fri Mar 04, 2005 10:02 pm

thats great news!

Derno24 · #3 Post by **Derno24** » Fri Mar 04, 2005 10:42 pm

Good news Will. I would take the whole enchilada for $300 like C27 posted on the other site.

I have the basic D&M kit now.

Hope this helps!

cannondale27 · #4 Post by **cannondale27** » Sat Mar 05, 2005 3:07 am

So your the secret programer!Right on.I cant wait.

guthrie08 · #5 Post by **guthrie08** » Sun Apr 03, 2005 6:45 pm

i would be willing to pay for 250 for the complet kit. this is a great alternative to the d&m.

moto440 · #6 Post by **moto440** » Mon Apr 04, 2005 4:44 pm

i currently have been using a friends d and m that has my code in it so cost for me has be zero but i would like to get one for myself sometime in the near future so i am hoping for this to be a golden opportunity!! would have no problem paying 300 for it either!! keep up the good work guys

timbomoose · #7 Post by **timbomoose** » Wed Apr 13, 2005 4:50 am

would be interested also

Josh · #8 Post by **Josh** » Wed Apr 13, 2005 5:06 am

I'm game also... dont have a D&M, how long would the wait be??

Derno24 · #9 Post by **Derno24** » Wed Apr 13, 2005 10:30 am

Will I dropped you a PM!!!

02Cannibal · #10 Post by **02Cannibal** » Wed Apr 13, 2005 12:26 pm

QUOTE

Originally posted by Josh
I'm game also... dont have a D&M, how long would the wait be??

I don't have an answer for how long right now. We hope not much longer though...

We decided to make a change to the design of the cable and make it a true USB cable rather then RS232 since serial ports are getting hard to find on newer computers.

The software is about 80% finished. The hard work is done, it's just down to finishing up a few things. I will try to keep everyone updated on the when part.